

K3v112dt Kawasaki Hydraulic Parts

Kawasaki k3v112dt hydraulic pump is a representative of axial piston hydraulic pump, which consists of two pump gears installed on the same shaft, distributes the rotational force to each shaft through the gear mechanism, and transmits the rotational force of the prime mover to the front drive shaft to drive the two pumps, it can also drive auxiliary pumps installed on different shafts. The k3v112dt Kawasaki hydraulic pump parts consist of two symmetrical rotor piston pumps at the front and rear and corresponding regulators and pilot pumps, each with a rotating swash plate and rotating swash plate adjusting screw for regulating the maximum and minimum flow rate.

Main pump part: The main pump part of the hydraulic pump is mainly used to control the slewing parts of the slewing movement; Inclined plate assembly for controlling hydraulic oil drainage; valve body assembly for switching the suction and discharge of hydraulic oil; and components for transmitting the gear pump drive shaft.

1、Turn the components. Rotating components include drive shafts, cylinder blocks, plungers and sliding shoes, setting discs, ball bushings, collars and hydraulic cylinder springs. The propeller shaft is supported by bearings at both ends. The hoof block is embedded in the plunger, forming a spherical connection. It has a groove that reduces the thrust caused by the load pressure for hydraulic balance, so it can move slightly on the shoe tray. Under the action of hydraulic cylinder springs, the assembly consisting of a plunger and a shoe block is tightly pressed against the shoe disc by a seat and a ball shaft sleeve. Similarly, under the action of hydraulic cylinder springs, the cylinder block presses the valve disc.

2、Rotate the swash plate assembly. The rotary swash plate assembly consists of a rotating swash plate, a shoe plate, a rotating swash plate support, an oblique bushing, an oblique pin and a servo plunger. The rotating swash plate is a cylindrical component that forms a cylindrical surface on the opposite side of the sliding surface of the hoof block. and supported by a rotating swashplate. When the hydraulic pressure controlled by the regulator enters the hydraulic chamber located on either side of the servo plunger, if the plunger moves to the left or right, the swash plate slides over the swash plate support through the spherical portion of the oblique pin, thus changing the tilt angle.

3、Valve body assembly. The valve body assembly includes a valve body, a valve disc and a valve disc pin, and the valve disc with two arc-shaped oil ports is fixed on the valve body, from the cylinder block to collect oil or supply oil to the cylinder block, and the oil changed by the pilot valve disc is connected to the external pipeline through the valve stem. If you look closely at a single plunger, it will make a movement away from the valve disc within 180 degrees (oil absorption process) and another 180 degrees towards the valve disc (or oil drain process). When the inclination angle of the rotating swash plate is 0 degrees, the oil drain is not carried out without the plunger forming.

Elephant Fluid Power is one of the manufacturers of Kawasaki pump parts , Elephant Fluid Power pump parts are compatible with kawasaki pump parts, Elephant Fluid Power and the price is very favorable, very suitable for market needs.

Elephant Fluid Company produces several series of hydraulic pump parts, and will strictly follow production standards, pay attention to details, and strive for excellence. Choose Elephant Fluid Company to give you a better experience!

k3v112 hydraulic pump

k3v112 gear pump

k3v112 regulator

k3v112 pump

k3v112 seal kit

k3v112 valve plate

k3v112 parts

k3v112 check valve

k3v112 solenoid valve

k3v112 charge pump

pump k3v112

kawasaki hydraulic pump k3v112